![xilinx verilog tutorial for beginners xilinx verilog tutorial for beginners](https://image.slidesharecdn.com/verilogtutorial-120525060602-phpapp02/95/verilog-tutorial-51-728.jpg)
Select the switch.v tab in the editor window. The Design Summary tab on the editor window will be selected after you generate your new module for now, you can close this tab with the X button in the upper-right corner.
Xilinx verilog tutorial for beginners windows#
There are four main windows in the Project Navigator: Sources in Project, Processes for Source, console output, and the editor. Once your module is generated, the main ISE Project Navigator view appears. Finally, notice the reset button on the right side of the board (next to the PS/2 ports) if you hold this button down for two seconds, the board will reset and reload the self-test. Pressing the five pushbuttons will emit tones from the audio output ports. The user switches (the blue component with four white switches, SW7) can be used to turn the user LEDs (D7-10) on and off.
![xilinx verilog tutorial for beginners xilinx verilog tutorial for beginners](https://i.ytimg.com/vi/onMmG_U4SVo/mqdefault.jpg)
If you type on the keyboard, the last keystroke will be displayed on the monitor. The red "System ACE error" LED will blink because no compact flash card is inserted into the board this is normal. LEDs will turn on and flash, and the self-test should appear on the monitor.
![xilinx verilog tutorial for beginners xilinx verilog tutorial for beginners](https://s3.studylib.net/store/data/008634025_1-8a4678b730429f1b60bca89d9e243cd1-768x994.png)
Turn the power switch (next to the power cable connector) to on. Set both of the switches to on/up this will load the "golden" self-test configuration from the PROM. Locate the blue component on the right side of the board with two white switches on it (SW9). Finally, you must set the configuration switches to load the self-test. If you have headphones, you can connect them to the amp out or line out ports on the left side of the board to hear tones, but do not put them on your ears, as the volume will be loud. Connect one of the monitors at your workstation to the display port on the left side and connect a keyboard to one of the PS/2 ports on the right side. First, set up your board by plugging the power cable into the connector on the upper-left corner of the board.